Raspberry Pi - Gert VGA 666 - GPIO to VGA

It is a neat and very useful solution for using a VGA screen/monitor with your Raspberry Pi and is far cheaper than an HDMI to VGA adapter or similar. The VGA connection is driven natively in hardware over the GPIO pins (using a parallel interface) and uses around the same CPU load as the HDMI connection on board. It is capable of displaying 1080p60 VGA video with no CPU load. It is also possible to drive this interface at the same time as the HDMI connection, so a dual screen set up is also possible.

This add on was not possible on the Model A and B pis, because not all of the required pins had been brought out to the GPIO header. Yet another awesome upgrade that the Model B+ has allowed for!


1 x Gert VGA 666 PCB
1 x 40 pin GPIO header connector
1 x 15 pin female VGA connector
20 x through hole resistors (2*120 Ohm, 3*499 ohm, 3*1kOhm, 3*2kOhm, 3*4kOhm, 3*8kOhm, 3*16kOhm)
2 x  Pi Supply Stickers

by GDPR 05-01-2021, 27 Apr 2016

Merhaba, Dirençleri resimde görüldüğü şekilde lehimleyebilirsiniz;

by GDPR 05-01-2021, 26 Apr 2016

İnternet siparişi ile aldığımız bu ürün 4 parça geldi. Plaka-Soket-VGA soket-Direnc Gelen Dirençler 3x0,50 2x0,12 3x2.00 3x4,21 3x8.10 3x8,90 3x15,80 Plaka üzerinde Direnç yerleşimi ve Şeması ne olmalı ?

VGA666 [JPG, 900.63 KB]
 Linkedin - Samm Teknoloji  Youtube - Samm Teknoloji  Instagram - Samm Teknoloji  Twitter - Samm Teknoloji  Facebook - Samm Teknoloji
Scroll To Top