TraceTek TT3000 Sensing Cable for Conductive liquids
The TraceTek TT3000 sensor cable is used to detect spills and leaks of aqueous chemicals which includes waste water, acids, bases, hazardous waste streams, etc.
TraceTek TT3000 sensing cable detects the presence of conductive liquids at any point along its length. Most acids and bases and even deionized water can be sensed and located. Installed with a TraceTek alarm and locating module, the cable senses the presence of fluid, triggers an alarm, and pinpoints the location
TT3000 sensing cable provides distributed leak detection and location over a wide range of areas. The cable is available in a variety of lengths to provide as much coverage as needed.
TT3000 sensing cable is available with factory-installed metal connectors that plug together. The measurement circuit is not dependent upon the conductivity of the leaking fluid. Therefore, the same cable will detect a wide range of fluids without special design considerations or calibration.
The cable is designed for a variety of applications, including floor surfaces, subfloors, equipment locations, pipes, storage tanks, and trenches. The cable is small, lightweight, and flexible, allowing easy installation. The smooth design allows quick drying.
The Raychem conductive-polymer technology and fluoropolymer construction make TT3000 sensing cable mechanically strong and chemically resistant. The cable is constructed of two sensing wires, an alarm signal wire, and a continuity wire embedded in a fluoropolymer carrier rod.
This rugged construction exposes no metal, and enables the cable to be reused even in corrosive environments.
|TraceTekTT3000_BulkSensingCable_InstallationManual||[PDF, 1019.73 KB]|
|TraceTekTT3000-Datasheet||[PDF, 1019.73 KB]|
|TraceTekTT3000Bulkcable-InstallationManual||[PDF, 1.37 MB]|
|TraceTekTT3000TT5000ModularInstallationManual||[PDF, 1.37 MB]|