GBP
  • TRY
  • USD
  • EUR
  • GBP
+90 444 1 726
Filters

ELEKTRA Floor Heating MD Heating Mat 160

Electrical Underfloor Heating - Turkey - ELEKTRA

 

 

  Floor heating
as the most favourable
heating solution

 

Of all heating systems, floor heating’s vertical
temperature distribution in a room is the closest form
of heating to the physiological body temperature
distribution.
Floor heating is a low temperature heating solution
(floors will reach temperature levels of approx. ),
the entire floor constitutes the heating element.
The advantages of these characteristics
are as follows:
• no combustion and dust convection
which causes allergies,
• no draughts,
• no drastic temperature differences in rooms,
• no dry air.


 

Electrical Underfloor Heating - Turkey - ELEKTRA with Thermostat OCD5 1999 Good for Allergy
 

 

Electrical Underfloor Heating - Turkey - ELEKTRA   Floor heating means:

• indoor climate comfort for users
– even room temperature distribution,
favourable warm floor effect,
• interior designs are not compromised
by bulky heaters, boilers, chimneys,
and water or gas pipes,
• low capital costs,
• decentralized heating – regulation
and control of individual rooms
possible.

 

Electrical Underfloor Heating - Turkey - ELEKTRA Ideal Profile OCD5 1999
 
 
   

Electrical Underfloor Heating - Turkey - ELEKTRAElectrical Underfloor Heating - Turkey - ELEKTRA  MD Heating Mat Cable

 
 

      Efficiency of electric floor heating will depend upon the
floor thermal insulation’s thickness. This variable
is especially significant for ground floors
or floors positioned above unheated rooms.
Approved finishing materials for heated floors
are as follows:


      • floor tiles such as marble, ceramic,
       porcelain or terracotta,
      • fitted carpet (of max. thickness 15 mm
      including underlay),
      • PVC / Vinyl flooring,
      • thin floor-glued wood parquet,
      • laminate / engineered wood.


Each of the above materials (with the exception
of floor tiles) must be approved by their producers
for applications with floor heating. Also, they must be
installed according to the producers’ instructions.

 

 Electrical Underfloor Heating - Turkey - ELEKTRA Carpet and Vinyl for OCD5 1999

Electrical Underfloor Heating - Turkey - ELEKTRA

  Floor heating system can be
developed on the basis of:

 

 


    1. ELEKTRA VCD heating cables
    2. ELEKTRA MG/MD heating mats
        and ELEKTRA DM/UltraTec
        heating cables
    3. ELEKTRA WoodTec1 and WoodTec2
        heating mats


placed in a screed at construction stage.
placed in the layer of flexible
adhesive or self-levelling compound
laid directly under the finished floor
on the floor base (concrete or timber).

suitable for placing under laminate
or engineered wood flooring.



 

Electrical Underfloor Heating - Turkey - ELEKTRA

 

 

 

 

ELEKTRA VCD heating cables are usually

used as a primary room heating, constituting
the only heating element in a room.


ELEKTRA MG/MD heating mats
and ELEKTRA DM and UltraTec heating
cables are then normally used as
supplementary heating systems,
in order to achieve the warm floor effect.
They can, however, constitute the primary
heating system, if required.

 

 

 

Electrical Underfloor Heating - Turkey - ELEKTRA  in a layer of flexible or self adhesive compound
 

 

Warm floor effect

Electrical Underfloor Heating - Turkey - ELEKTRA
Heating system placed in a layer of flexible adhesive

or self-levelling compound, directly under the floor


To achieve the warm floor effect, the following
heat output options are recommended:


 - 100-120 W per m²of the floor when tiles or stone are
the floor finishing materials,

   - 100 W per m² of the floor when PVC or fitted carpet are the floor finishing materials.


For the shortening of the warm-up time,
it is recommended to install approx. 50%
higher heat output per 1 m of the floor
(only for tiles or stone floorings),
when the heating system is not intended
for permanent operation
 

 

e.g. in hotel rooms or offices, and additionally
in situations when temperature controllers
with temperature set-back option will be used
for heating regulation purposes.
For the cases above, the following
can be used:
• ELEKTRA MG/MD heating mats,
• ELEKTRA DM and UltraTec heating
cables.
The heating mats’ structure is a thin heating
cable fastened to a 50-cm-wide fiberglass mesh.
The mats are simpler in installation than
cables themselves: self-adhesive properties
facilitate floor fastening of the mats, when
the DM or UltraTec cables must be attached
to the floor.


 
Electrical Underfloor Heating - Turkey - ELEKTRAElectrical Underfloor Heating - Turkey - ELEKTRA ultratec thinner than a matchElectrical Underfloor Heating - Turkey - ELEKTRA  WoodTec OCD5 1999
 

Electrical Underfloor Heating - Turkey - ELEKTRA

Heating system placed on an insulating
 underlay under laminate- or engineered
 wood floorings

 

To achieve the warm floor effect, it is
recommended to have heat output of 60-70 W
per m of the floor installed. For this purpose,
the ELEKTRA WoodTec™ heating mats are best
suited. The heating mats’ structure is a thin
heating cable glued to a fiberglass mesh
on one side, and totally covered with aluminium
foil on the other. The foil acts as a protective
screen for the heating cable, as well as
a radiation intensity amplifying element,
transferring the cable’s heat directly
to the flooring material.

 

 

Electrical Underfloor Heating - Turkey - ELEKTRA
Heating system placed
in a cement slab layer
 

To achieve the warm floor effect, the following
heat output options are recommended:
• in cement slabs destined for
tiles or stone floor finishing
­ ELEKTRA VCD17 or VCD10 heating
cables of approx. 85 W/m ,
• in cement slabs destined for floor
finishing other than tiles or stone
­ ELEKTRA VCD10 heating cables
of approx. 65 W/m .
For the shortening of the warm-up time, it is
recommended to install approx. 50% higher
heat output of the floor, when the heating
system is not intended for permanent operation
or temperature controllers with temperature setback option will be used.

Electrical Underfloor Heating - Turkey - ELEKTRA

 

ELEKTRA Floor Heating MD Heating Mat 160

Power output 100, 160 or 200 W/m2 (200 W/m2 applicable in the UK only)
Power supply 230 V ~ 50/60 Hz
Mat thickness ~ 3.9 mm
Min. installation temperature -5°C
Max. working temperature +110°C
Conduit cables 1 x 4 m; 3 x 1.00 mm2
Type of heating cable double-core of diameter — 3.4 mm, conductor screen,
  single-side power supply
Power output of heating cable ~ 7 W/m (MD100), — 10 W/m (MD160), — 12 W/m (MD200)
Insulation double layer, FEP + XLPE
Outer sheath XLPE
Rated power output tolerance +5%, -10%
Min. radius of bending cable 5 D
Protection IPX7
Product certificates VDE, GOST-R
Certificate of ISO 9001 IQNET, PCBC
Product mark CE


Electrical Underfloor Heating - Turkey - ELEKTRA Electrical Underfloor Heating - Turkey - ELEKTRA

▲ Back to the top
Maximum
İş Bankası
Installment
number
InstallmentTotal
2 £124.40£248.79
6 £41.47£248.79
9 £29.30£263.72

FileInfo
Yerden Isıtma [PDF, 959.26 KB]
Donmaya Karşı Koruma [PDF, 2.12 MB]
Kar ve Buza Karşı koruma [PDF, 2.88 MB]
Floor_Heating [PDF, 1.26 MB]
MD Datasheet [PDF, 210.04 KB]
 Google Plus - Samm Technology  Youtube - Samm Technology  Facebook - Samm Technology  Twitter - Samm Technology  Facebook - Samm Technology
Scroll To Top